Ok, I'll try again; The second image shows the shavings after about 800 rounds of .223, and you can see the Lee decapper on the RCBS die. The switch is a Radio shack special, seemed like it was designed for it. The motor is from
www.surpluscenter.com The plug if from a cpu wiring harness chopped up, the cutter is a knocked down, drilled & set screwed boring bar, and the bolt on top takes out the slop and keeps the stress off the motor's bearings. It is line bored and has a single ball from a ball bearing to prevent friction. I accidentally got a 24 volt ac power supply, so I had to put in a rectifier, but you can buy a 24 dc supply from surplus center. Just make sure it puts out enough amps or you'll fry the power supply. (no cell phone chargers or the like) Thanks for the help JMORRIS!