The Firing Line Forums - View Single Post

brentfoto · May 25, 2008, 07:47 PM

Thanks for that trigger job link.

I thought the general rule of thumb is to not clip coils, but I guess there are exceptions.

I've had a hard time clipping coils myself. Perhaps I don't have the correct tool. Suggestions?

If I'm going to have him replace the mainspring I might as well, according to your suggestion, have him clip the coils as well as part of the process.

So, your advise is to go with the Beretta D and not the Wolff, and this is because you have personal experience with the Beretta D and not the Wolff 16# hammer spring?

Prompt reply appreciated!

May 25, 2008, 07:47 PM	#21
brentfoto Senior Member Join Date: August 20, 2007 Location: SoCal Posts: 362	Thanks for that trigger job link. I thought the general rule of thumb is to not clip coils, but I guess there are exceptions. I've had a hard time clipping coils myself. Perhaps I don't have the correct tool. Suggestions? If I'm going to have him replace the mainspring I might as well, according to your suggestion, have him clip the coils as well as part of the process. So, your advise is to go with the Beretta D and not the Wolff, and this is because you have personal experience with the Beretta D and not the Wolff 16# hammer spring? Prompt reply appreciated!