The Firing Line Forums - View Single Post

pak_a_bowl · April 6, 2009, 05:06 PM

well, after reaaallly lookin at it i can see that the rear of the bolt is either pressed to make it smaller, or the hammer has just hit it sooo many times in the last 40-50 years its smashed in, so my question too you is... was it done like this intentionaly? or is it internal wear?

April 6, 2009, 05:06 PM	#9
pak_a_bowl Junior Member Join Date: February 21, 2009 Posts: 3	ok well, after reaaallly lookin at it i can see that the rear of the bolt is either pressed to make it smaller, or the hammer has just hit it sooo many times in the last 40-50 years its smashed in, so my question too you is... was it done like this intentionaly? or is it internal wear?