|
Forum Rules | Firearms Safety | Firearms Photos | Links | Library | Lost Password | Email Changes |
Register | FAQ | Calendar | Today's Posts | Search |
|
Thread Tools | Search this Thread |
April 4, 2009, 02:46 PM | #1 |
Member
Join Date: March 31, 2009
Location: ohio
Posts: 70
|
Want to know about western marshal 44 mag.
I recently bought a western marshal revolver that needs a little work for 70.00, it shoots fine but the the problem is that hammer will not stay at full cock. I was wondering if anybody knew anything about them good or bad and if anybody knew where i could get some parts for it to get it back to good functioning condition.
thanks, Brandon |
April 4, 2009, 05:08 PM | #2 |
Senior Member
Join Date: November 2, 2005
Location: Arizona
Posts: 1,936
|
Imported by Hawes in the 60s and 70s, Made in Germany by J P Sauer and Sohn. Compared to the Rugers and Colts they were inexpensive guns. They were copies of the Colt 1873, not a clone so parts might be hard to find. Try Numrich Gun Parts Corp. 70 dollars, you didn't pay too much.
|
April 4, 2009, 05:33 PM | #3 |
Member
Join Date: March 31, 2009
Location: ohio
Posts: 70
|
thanks i checked them out they seem to have the parts i just have to find out exactly what i need, it seems that someone may have tried to lighten the action on it and maybe went to far now it wont hold itself back...
|
April 14, 2009, 10:34 AM | #4 |
Member
Join Date: March 31, 2009
Location: ohio
Posts: 70
|
couldn't buy parts to fix the problem so my buddy is fabing them shouldn't cost me more that 15.00 needed a new pin that had broken and a worn out spring other than that it should be good as new.
|
|
|