|
Forum Rules | Firearms Safety | Firearms Photos | Links | Library | Lost Password | Email Changes |
Register | FAQ | Calendar | Today's Posts | Search |
|
Thread Tools | Search this Thread |
June 17, 2002, 03:07 PM | #1 |
Junior Member
Join Date: June 13, 2002
Location: Fairmont, WV
Posts: 1
|
Does anyone make a 380 SWC?
Does anyone make a 380 Semi-wad cutter? Will they cycle in a Colt Mustang? I'm looking for one to plink with.
Thanks in advance, Pete
__________________
Tracers work both ways... |
June 17, 2002, 03:16 PM | #2 |
Senior Member
Join Date: February 28, 2002
Location: Canton, Oh
Posts: 896
|
Not that I'm aware of, but you can get a 95gr RN lead, Laser Cast, Meister and National Bullet company all make .380 RN.
How well does the mustang feed HP's? I've never had a problem with my makarov, suspect I could to SWC's, but I don't know if there's enough room on that small bullet to make the WC part robust enough.
__________________
DoD# 2223 Meum scapha volitare plenum anguillae |
June 17, 2002, 04:26 PM | #3 |
Member
Join Date: July 20, 2001
Location: ALABAMA
Posts: 78
|
don't know about bullets but lee makes a 105 grain swc mould that is suposed to be good in 9mm(it is 358 but can be sized down) since it is light enough should be ok in 380 if it will feed
|
June 17, 2002, 04:28 PM | #4 |
Senior Member
Join Date: February 28, 2002
Location: Canton, Oh
Posts: 896
|
I know that'd work in my Makarov, YMMV though.. I 've shot 115gr .355 XTP's outta my mak at 950fps or so.
That's up in the +P level for sure, so I wouldn't suggest running it through the colt
__________________
DoD# 2223 Meum scapha volitare plenum anguillae |
|
|