Oh Snap! Saran Wrap.... good thinking
The paper worked fine tho...still needs to be loosened a little for a smooth draw....
Galco did e-mail me back and recoomended this also
Thank you for your purchase. CON440H is the correct product code for the Springfield XD 4” barrel, so please just verify that these are the numbers on the back of the holster. If the numbers match up, it sounds like you just need to break in your holster. Our holsters (especially the Havana ones) are normally quite tight when new, and yours is a common question. To break in the holster, begin by working the leather with your hands, bending and flexing the holster in all directions. Don’t fold it in half or anything, but don’t be afraid to flex it. This will warm and stretch the fibers of the leather.
After flexing the holster body for about ten minutes. Take the unloaded pistol and jam it into the holster as far as you can possibly make it go. Take it out and jam it in again. Do this about 20-30 times. This should relax the holster enough to accommodate your pistol.
If you have any further difficulties, please don’t hesitate to contact us again.
Thumbs up for Galco Customer Service
