The Firing Line Forums - View Single Post

Rem#11 · February 9, 2009, 03:19 PM

It has a round firing pin. Where on the barrel would I find the letter?

I see I forgot to say it has the "Checkered Stocks" and it's a 12 Gauge (added to original post).

Do they all have the flying duck on the left side and a pheasant on the ground, on the right side?

I've also run across some information about setting up the friction rings for different ammo and find that the information about the steel friction ring doesn't jive with the one I have. It notes that it's very important to install this ring correctly, but the bevel on mine is on the inside of the ring and not on the outside.

Do I measure the complete length of the barrel for length or is there some point along the assembly that I stop at? How do I tell if it's plain or matted rib barrel?

February 9, 2009, 03:19 PM	#26
Rem#11 Junior Member Join Date: February 9, 2009 Posts: 2	It has a round firing pin. Where on the barrel would I find the letter? I see I forgot to say it has the "Checkered Stocks" and it's a 12 Gauge (added to original post). Do they all have the flying duck on the left side and a pheasant on the ground, on the right side? I've also run across some information about setting up the friction rings for different ammo and find that the information about the steel friction ring doesn't jive with the one I have. It notes that it's very important to install this ring correctly, but the bevel on mine is on the inside of the ring and not on the outside. Do I measure the complete length of the barrel for length or is there some point along the assembly that I stop at? How do I tell if it's plain or matted rib barrel? Last edited by Rem#11; February 9, 2009 at 03:38 PM.