Friction Ring Type
as Rem#11 observed the FRICTION RING is different than shown in the instructions. his (and mine) are just cylinders (about 3/16~1/4 thick) on the exterior and have a bevel on the inside (one end only). the instructions show a FRICTION RING that has a cylindrical section and a conical section (external) on one end. the instructions are VERY specific on which direction the 'OUTSIDE BEVEL' faces depending on the load you are setting the gun up for. i (and probably Rem#11) would greatly appreciate knowing which way OUR FRICTION RINGS should be assembled. attached are the instructions i refer to above. thanks for any help.
|