The Firing Line Forums - View Single Post - Trigger of Ruger Mk III compared to that of Browning Buckmark.

btolliverjr · December 26, 2008, 04:03 PM

In order to eliminate the mag disconnect safety in the MKIII is it necessary to replace the parts? In this link http://scromp.net/ruger/Site/HOWTO.html it shows simply to remove the disconnect lever and spring then re-assemle! No replacement parts needed?

December 26, 2008, 04:03 PM	#9
btolliverjr Senior Member Join Date: December 26, 2008 Location: SW Ohio Posts: 423	In order to eliminate the mag disconnect safety in the MKIII is it necessary to replace the parts? In this link http://scromp.net/ruger/Site/HOWTO.html it shows simply to remove the disconnect lever and spring then re-assemle! No replacement parts needed?