The Firing Line Forums - View Single Post - Reloading bench

remshooter · December 11, 2007, 08:51 AM

While you can't have too much storage space, those drawers under the table top would get in my way the way I sit at the bench. I am right handed so I sit to the left of the press kinda at an angle.

Other than that it is a jam up bench.

For what its worth I bolted all my presses to a piece of 1/2" aluminum about 5" x 7" and then bolted that to the table so as to clear the braces in the table. Where ever you put the press make certain you have LOTS of support under it. You don't want the press rocking when you pull on the handle.

We want to see a picture when you get r done.

December 11, 2007, 08:51 AM	#12
remshooter Member Join Date: October 13, 2006 Location: NC Posts: 84	While you can't have too much storage space, those drawers under the table top would get in my way the way I sit at the bench. I am right handed so I sit to the left of the press kinda at an angle. Other than that it is a jam up bench. For what its worth I bolted all my presses to a piece of 1/2" aluminum about 5" x 7" and then bolted that to the table so as to clear the braces in the table. Where ever you put the press make certain you have LOTS of support under it. You don't want the press rocking when you pull on the handle. We want to see a picture when you get r done.