The Firing Line Forums

Go Back   The Firing Line Forums > Hogan's Alley > Handguns: General Handgun Forum

Reply
 
Thread Tools Search this Thread
Old January 19, 2000, 04:06 PM   #1
TaxPhd
Senior Member
 
Join Date: October 29, 1998
Location: Colorado
Posts: 534
I have always felt reasonably competent around firearms, and while I am certainly no gunsmith, detail stripping any of my guns has never been a problem. I just can't figure this one out.

How do you remove the trigger on a HP? It appears as if the trigger assembly is held in place by one pin, but that pin doesn't want to move. Do you push from the left side or the right side to remove it? Does something else need to be done to "free up" this pin? Help!
TaxPhd is offline  
Old January 19, 2000, 04:57 PM   #2
labgrade
Member In Memoriam
 
Join Date: November 29, 1999
Location: west of a small town, CO
Posts: 4,346
Drive the pin out from the right hand side (as you hold to shoot).

Too, once the pin is out, remove the trigger lever. Then, you'll have to rotate the trigger to actually get it through the trigger guard.

Pretty much a pain in the butt to re-install as you need an extra hand to get that trigger lever back in. Helps a bunch to mount the frame in a padded vise before trying the re-install.
labgrade is offline  
Reply


Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 12:45 PM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2024, vBulletin Solutions, Inc.
This site and contents, including all posts, Copyright © 1998-2021 S.W.A.T. Magazine
Copyright Complaints: Please direct DMCA Takedown Notices to the registered agent: thefiringline.com
Page generated in 0.05004 seconds with 10 queries